JIMS

Used to hold flywheel assembly in vise, with or without left case attached Made in the U.S.A.   Fitment Guide 2006 Harley-Davidson FLHX Stree...

Holds the rods in place when reaming or honing the wrist pin bushings Made in the USA For most V-Twin and Buell Blast applications.   Specs T...

These tappets will run in cast iron or aluminum tappet blocks Recommend fitting the tappets to the blocks with a clearance of .0007" to .0012" Pro...

These tappets will run in cast iron or aluminum tappet blocks Recommend fitting the tappets to the blocks with a clearance of .0007" to .0012" Pro...

These tappets will run in cast iron or aluminum tappet blocks Recommend fitting the tappets to the blocks with a clearance of .0007" to .0012" Pro...

Only when the tip fits nicely with no endplay is the tappet properly adjusted, if the tip doesn’t fit, OR if there is up and down endplay, the tap...

These tappets have undergone extensive development to increase load, lubrication, hydraulic and life capacities Billet body Increased roller width...

Perform like a hydraulic tappet up to 5500 rpm, then turn into a solid tappet When they turn into solid tappets, it adds approximately three to ...

Perform like a hydraulic tappet up to 5500 rpm, then turn into a solid tappet When they turn into solid tappets, it adds approximately three to si...

Perform like a hydraulic tappet up to 5500 rpm, then turn into a solid tappet When they turn into solid tappets, it adds approximately three to ...

Includes shaft and bushing Made in the U.S.A.   Fitment Guide 1965-1969 Harley-Davidson Electra Glide FL - - 1965-1969 Harley-Davidson 1200...

Locates on ignition switch face nut that holds switch in place to remove or install switch without damage 3/8" drive access hole Made in the U.S.A...

Also used to position switch in the correct orientation for properly activating the fork lock Proper alignment of the switch will extend the life ...

Also used to position switch in the correct orientation for properly activating the fork lock Proper alignment of the switch will extend the life ...

Slip the dog bone end of tool into the bottom side of connector until it is touching the back end of connector box Then gently pull out the male w...

Used to remove inner cam bearing without damaging the crankcase Tool is also designed to keep rollers from falling into the crankcase Comes with i...

Used to remove inner cam bearing without damaging the crankcase Tool is also designed to keep rollers from falling into the crankcase Comes with i...

Replacement sealNOTE: For use with Inner Primary Bearing Upgrade Kit PART #1120-0242.   Specs Product Name Bearing Kit Type Inner Primary ...

Safely removes and installs inner primary bearing without any damage to new bearing by pushing on outer perimeter of bearing Also removes and inst...

Safely removes and installs inner primary bearing without any damage to new bearing by pushing on outer perimeter of bearing Also removes and inst...

Safely removes and installs inner primary bearing without any damage to new bearing by pushing on outer perimeter of bearing Also removes and inst...

Gives a much better feel than a press while eliminating the possibility of applying too much pressure to the parts Provides precise installation a...

Use to inspect oil filter for any damaging particles that may be trapped in filter Locks down filter for a clean cut around filter base Fits filte...

Aligns wheel with swingarm, caliper brackets, wheel hubs and spacers Made in the USA For Big Twin models with hollow 1" (25 mm) standard axles   ...